Press brakes bend sheet metal into precise angles. Choose a 5-axis CNC press brake to suit your bending length and tonnage. The range includes a graphical controller, safety equipment and standard Euram tooling.
Featured machine: new 3400 × 125T CNC press brake · £30,883 + VAT and delivery
Watch the controller, bending beam and backstop together as the machine runs the same six-step programme.
Separate dry-run recordings synchronised by programme step, without sheet material. Watch for the highlighted 250 mm automatic backgauge retraction. Use full screen for a closer view.
The graphical controller advances through six programmed steps. The front view shows the upper beam lowering and returning. The rear view shows the backstop changing position between steps. All three views show the same programme on the Carter 5-axis press brake, including 250 mm automatic backgauge retraction for clearance.
The video could not load. Open the demonstration directly or try again.
Watch Alex enter a profile and work through the bend settings on this machine’s controller. The graphical shape and programme table show how the job is set up.
Original demonstration on the 3400 × 125-tonne press brake. Use full screen to read the settings.
All prices below are + VAT and delivery. Ask us to confirm availability and the specification for your chosen size. Larger sizes available on request.
Tap a feature photograph to view it full size.
See the 3400 × 125-tonne press brake from the front, sides and rear. Select a photograph or swipe through the available views, then zoom in for a closer look.
Front · 1 of 6Six views of the actual machine. Swipe, drag or use the arrow keys to browse.
Images show representative press-brake equipment. Your quotation confirms the specification for the capacity you choose.
2D touchscreen programming with graphical bend setup, tool library and programmable sequence.
Safety-tang holders make tool changes straightforward. Fiessler laser guards protect the point of operation.
The fingers run on linear guides and can be positioned by hand across the machine to suit the workpiece.
The motor moves the gauge under CNC control for repeatable positioning. Actual accuracy depends on setup and calibration.
Tap a photograph to view it full size.
Crowning, electrical and guarding equipment on the 3400 × 125-tonne press brake. Select an image to inspect the detail at full size.
The drive and gearbox at the end of the lower bed. The controller’s crowning setting adjusts the mechanical compensation system.
How crowning works
The transmitter and receiver fitted beside the tooling, shown with their original labels and indicators.
A clear view of the control equipment, labelled wiring terminals and drive units fitted to this machine.
This Carter press brake uses Y, X, R, P and ADS. The labels below describe the actual machine controls; the photograph shows its backgauge fingers in place.
Z1/Z2 · Manual finger spacing
Each finger slides across the machine width by hand. Z1 and Z2 are not powered CNC axes.
As bending force rises, the beam and bed can deflect along their length. The ADS controller calculates the required correction automatically, then powered mechanical wedges adjust bed support to help maintain a consistent bend angle from end to end.
Illustration is schematic; required crown depends on the machine, material, thickness and bend length.
Browse the Euram punches and dies catalogue or use the bending guide to estimate force and preview a bend setup.
Call for sales, spares, service or a quotation.
All new machines include a 24-month parts-and-labour warranty. Ask about part exchange, finance, delivery, offloading and positioning when requesting your quotation.
Finance is subject to approval. Delivery, handling and positioning are quoted for your machine and site.
